Application Technology Of Elevator

    An elevator is a permanent transport device that serves a certain floor in a building, which runs at least two columns perpendicular to the horizontal plane or a rigid track movement less than 15 ° from the plumb inclination angle. Also has the stair type, treads the board to install in the track continuously runs, commonly known as the escalator or the automatic sidewalk. Fixed lifting equipment for service on specified floors. The vertical lift elevator has a car, which runs between the rigid rails with at least two rows of vertical or sloping angles less than 15 °.Elevator
    Application technology: 1, full digital identification of passenger technology (all passengers before entering the elevator identification, including eye recognition, fingerprint identification) 2, Digital Intelligent Security control technology (through the passenger identification system or IC card and digital monitoring equipment, refused to enter into the foreign people) 3, the fourth generation of No engine room elevator technology (the host must be separated from the guide and the car, there is no resonant resonance, the speed can reach 2.0m S above, the highest can be used above 30 floors. 4, two-way security technology (two-way safety clamp, two-way speed limiter, in Europe must be used, China is widely used) 5, rapid installation technology (to change the past elevator installation methods, can be quickly assembled) 6, energy-saving technology (using energy-saving technology, to make the elevator more energy-saving) 7, digital monitoring technology (completely using the computer for elevator monitoring and control) 8, wireless remote control and alarm device (when the elevator failure, the elevator can be sent to the phone through the wireless device to send fault information, And through the mobile phone signal to the elevator simple control. )Elevator
    Manned elevators are computer-controlled intelligent, automated equipment, do not need special personnel to operate the driving, ordinary passengers as long as the following procedures to ride and operate the elevator can. 1, in the escalator floor elevator entrance, according to their own uplink or downlink needs, press the direction or the direction of the arrow button, as long as the button on the light on, it means that your call has been recorded, as long as the elevator arrival can be. 2, the elevator to open the door, first let the car inside the staff out of the elevator, and then the elevator into the lift car. After entering the car, according to the floor you need to reach, press the corresponding Number button on the control plate in the car. Also, as long as the button light is on, your selection has been recorded and no other action is required, as long as the elevator arrives at your destination level. 3, the elevator to your purpose layer will automatically open the door, at this time in order to walk out of the elevator is the end of a ladder process.Elevator