Some More Information About The Passenger Elevator

  1. The elevator has a layer gate in each service layer, the cage runs the direction indicator light, the mathematics display the cage, the operation position indicator layer and the call elevator button. When the elevator call button is used, go upstairs and press the direction button, and then press the direction button.

  2. the car arrived, floor direction indicator that shows the movement direction of the capsules, passengers after judge and determine the elevator to the direction normal to capsules, pay attention to the closing of the doors, don't stay at the gate of the layer and joint capsules the door.

  3. There are position display, control panel and open door button and floor selection button in the cage. After entering the cage, press the button of the selection layer to the floor. To close the door immediately, push the door close button. The position indicator light of the cage floor shows the arrival floor and can leave when the cage door opens.

  4. The rated load of this lift is 13, which cannot be overloaded. Please take the initiative to quit when you are overloaded.

  5. Passenger elevators cannot always be used as cargo lifts. They are not allowed to ship inflammable and explosive products.

  6. When an abnormal phenomenon or malfunction occurs in the elevator, be sure to calm down. You can make a rescue call in the cage.

  7. Passengers are not allowed to rely on the cage door, not to smoke and litter in the cage, to keep the cage clean and hygienic.

  8. Passengers should take good care of elevator facilities. They should not press buttons and pry doors.

  9. The driver shall strictly perform the duties of the post. During the operation of the elevator, the driver shall not stay away from the post, and find the fault timely handling and reporting.

  10. The driver should not be allowed to check and stop the button as normal before starting to eliminate the call signal; It is not allowed to use the maintenance speed on the floor and the cage door; It is not allowed to open the cage door and safety door; Do not allow the speed of maintenance to ship the excessive items; It is not allowed to use the starting or stopping function of the elevator as the elevator. Do not allow a sudden reversal in the exercise.

  11. The driver should check the operation condition of the elevator regularly, contact the elevator maintenance regularly, and make the maintenance record.

  12. When the elevator stops working, the operator should stop the cage at the base station and disconnect the switch on the operating disc and close the door. If there is a power failure notice, the elevator will be stopped in advance.